1. Install Vista RTM to a secondary partition (not the main boot partition). The primary reason for this is one doesn't want all the boot associated files of that computer related to BCD and boot.ini being part of the final image.
找一个空白分区安装VISTA RTM版，注意不要是主启动分区。
2. Once in the Out of Box Experience (OOBE) after setup, type Ctrl-Shift-F3 to enter Audit mode. In case you're wondering what/where OOBE is, it is the part after setup where the user is setting up his/her username, password etc
安装完之后会进入到OOBE屏幕，按CTRL+SHIFT+F3进到诊断模式（OOBE即是那个要输入用户名密码什么的那个屏）
3. The system will then reboot into Audit mode and a Sysprep window will pop up. Do not close the Sysprep window.
系统会重启到诊断模式，会弹出一个SYSPREP窗口，不要关闭它.
4. Run the Vista SP1 installer and let it do its thing
选择运行VISTA SP1的安装程序
5. After the SP1 setup is complete, you'll find yourself back at the main Vista desktop with the Sysprep window open and SP1 will be installed and ready to go. From the Sysprep selection window, select OOBE, Generalize, and to Shut Down the system
安装完SP后，你会回到VISTA的桌面，当然那个SYSPREP窗口还开着，选择OOBE，通常，并关闭系统。
6. Boot the system into a WinPE disk or another OS install (ie. XP), do NOT boot back into Vista, and run the following imagex command (imagex can be found in WAIK)
用一个带WINPE的光盘或U盘或者你安有双系统的话（XP之类的）启动，记着千万不要启动到VISTA，然后打入如下命令
imagex /compress maximum /flags "Business" /capture d: c:\install.wim "Windows Vista Business" where d: is the drive Vista is installed on and c:\install.wim is the location to store the new install.wim.
d:是指安装VISTA的那个盘，C:\INSTALL.WIM是指定产生的INSTALL.WIM存储的位置。可以由你自由指定
Replace "Business" with whatever edition of Vista you installed and replace the drive letters (d: and c:\install.wim) with your own
你可以指定VISTA的任一种版本，如BUSINESS, HOME BASIC等
7. Once the image has been built, replace the old install.wim in the Vista RTM ISO in \Sources\ with the newly created install.wim using a registered version of UltraISO (Version 8.0 or higher). Save the ISO and you're done.
在新的INSTALL.WIM生成后，将新生成的文件替换RTM ISO中的\SOURCES\下的老的INSTALL.WIM（如可以用ULTRAISO这个工具来替换。）
